Paul Falcon Cars 3 Posted September 10, 2020 Heater blower not working even on position four, can anyone help?? Share this post Link to post Share on other sites
MarkTVS 209 Posted September 10, 2020 Resistor more than likely Share this post Link to post Share on other sites
Casper 272 Posted September 10, 2020 Had the same on a c4 was the resistor ... Share this post Link to post Share on other sites
justina3 518 Posted September 10, 2020 No one is really going to be able to diagnose that over the internet, as the chaps have already mentioned resistor is one option, if you have no speeds at all could be the blower itself or the plug on the blower, i find most of our resistor faults allow one speed. 1 Share this post Link to post Share on other sites
Halfpenny 114 Posted September 10, 2020 The electrics on these can be dodgy. If the fan is not working at all then it may not be the resistor pack. It could be the connector on the fan. Remove the glovebox to get at it. A common 208 heater fault is melted wiring. In the passenger foot well there is a small panel at the front end of the centre console just in front of the heater outlet. It is held on with a single screw and clip.Behind this there is a small inline connector which has a grey wire and a green/yellow wire in one side and a red wire and green/yellow out the other side. This plug can melt inside causing high resistance. It is the 12V supply and ground to the resistor pack. 1 Share this post Link to post Share on other sites
